Automating slide staining is a must for labs that wish to increase their yield. The PolyStainer performs standardized staining procedures that free lab staff from labor-intensive staining procedures. General microbiology and histology labs that seek to reduce sample staining workloads will greatly benefit from its use.
Up to 20 microscope slides are loaded in the PolyStainer basket. Next the robotic arm will dip and stir these through four exchangeable plastic wells. Slides can be dipped in a fifth drainable water well that ensures water will be renewed after rinsing each slide basket. Last, slides can be fan dried with or without heat. The four reagent wells in the system allow to perform an extremely broad array of stains.


Walkaway Solution: A one push button operation triggers the entire staining procedure.
Unique Design: The PolyStainer was uniquely designed to separate its staining area from the system’s electronics and mechanics, this ensures endurance due to separation from highly oxidative reagents.
Staining Protocol Optimization: Ensures no cross contamination by using the PolyStainer’s rinsing well drain to keep rinsing water clean. Speeds stain preparation by drying out slides.


 Slides / Basket  20 slides each basket
 Basket Lifting Motor  2.6W 12V /c 141:1 /encoder
 Carriage Movement Motor  1.65W 12V / 28:1 / encoder
 Heater  12ºC-15ºC higher that the room temperature
 Heater Air Pressure  80 Pa
 Air Volume  30 m3/h
 Water Control  Electro valve 4W 24V IP65
 Water Flow Program  Permanent/Autoiniciated at previous bath
 Water Pressure  2bar / 6bar (instrument supplied with three different manifold)
 Optional Output  RS232
 Dimensions (WxHxD)  70x40x34
 Weight  23Kg
 Reagent Containers  Polyethylene
 Basket Holder  Stainless Steel AISI 304
 Basket  Stainless Steel AISI 304
 Additional connections  2 x USB Host ports
 for peripherals  
 Programming Memory  10 programs - 10 steps per program